Computer hardware for sale

4U tall 60 disk SAS 2 (6Gbps x 4 lanes) attached JBOD enclosure
Accepts 60 2.5 inch ("small form factor") SSDs or spinning hard drives. 60 disk trays included
Accepts SATA and SAS storage drives
dual power supply
dual fan modules
dual controller (host interface)
rackmount rails included
appropriate SAS signal cables included
faceplate/bezel (purely cosmetic) included
most hardware components (drives, controllers, fan modules, power supplies) are hot swappable. The internal backplane is not.
Final release firmware is installed (03.9F) on the interface modules (EMMs)
The interface modules (EMMs) do have Ethernet connections. They are configured for DHCP. Using them is strictly optional. No Ethernet is required to put this to use.
208/220/240 Volt power is required. Normal US household 110/120 Volt power will not do the job.
Physically larger than most servers. This will require extra depth in your rack. 32.5 inches deep
This is a JBOD (just a bunch of disks) device. A server connected to it will see 60 individual storage drives (if installed) and the enclosure itself. There is no hardware RAID.

PCIe card to attach your server to a fantastic Dell PowerVault MD3060e
Low profile PCIe Gen3 x8 card
5 high profile and 2 low profile brackets available. Please specify your needs here.
Dual 6Gbps 4-lane external SFF8088 ports with either bracket.

48 port 10/100/1000baseT Ethernet switches
Four 10Gbits/sec SFP+ ports in each. 2 of these ports are configured by the factory for stacking. But the stack functionality can be disabled them. So your choice: Two 10Gbits/sec server ports and two switch stacking ports, or three and one, or four server ports.
Power Over Ethernet enabled S3500-48P model
dual power supply capable
two 600 Watt power supplies available -- these are the standard C14 connector input you'd find on most any computer
four 1050 Watt port supplies available -- these use the high amperage C20 connector found on high power draw devices
all switches have rackmount ears installed on the front (port side)
two complete rack kits -- hardware to hold up the back of the switches and prevent sagging

Dell service tag/serial number/st 48RRJ32
2U server with 12x front mounted 3.5inch (LFF) hard drive bays and 2x rear mounted 2.5inch (SFF) hard drive bays
iDRAC enterprise license installed
2x Xeon E5-2620 CPUs installed (I have at least one pair of E5-2650v2 CPUs available if desired.)
64 Gibytes RAM installed. 4x 8Gibyte DIMMs + 8x 4Gbiyte DIMMs
All firmware up to date: iDRAC 2.65.65.65, BIOS 2.9.0, rNDC Ethernet 19.5.12
one power supply installed
ball bearing sliding rackmount kit included
Lifecycle Controller diagnostics passed 2026-09-01

Dell service tag/serial number/st 88RJJ32
2U server with 12x front mounted 3.5inch (LFF) hard drive bays and 2x rear mounted 2.5inch (SFF) hard drive bays
iDRAC enterprise license installed
1x Xeon E5-2620 CPU installed
16 Gibytes RAM installed. 2x 8Gibyte DIMMs
All firmware up to date: iDRAC 2.65.65.65, BIOS 2.9.0, rNDC Ethernet 19.5.12
one power supply installed
ball bearing sliding rackmount kit included
Lifecycle Controller diagnostics passed 2026-09-02

Contents